2N Telecommunications 9152101 Manual de instalación descargar pdf (Pagina 26)

262N TELEKOMUNIKACE a.s., www.2n.cz

Factory Default Resetting (PCB version 555v2)

Disconnect the device from the power supply.

Move the short-circuit jumper on connector X6 into the position.Default setup

Configuration jumpers (X6) are located in the right-hand upper corner of the

PCB.

Reconnect the power supply and wait for a start signalling sound.

Disconnect the device from the power supply.

Move the short-circuit jumper on connector X6 into the Normal operation

position.

Reconnect the power supply. The device will be reset to factory default.

Normal operation Default setup

Configuration jumpers X6, PCB version 555v2Figure:

Mounting Completion

Having connected all the wires, make sure that the bushings, if used, are

tightened properly and the RJ-45 connector is inserted in the PCB connector.

Replace the front cover carefully. Make sure that the connector is inserted

correctly and the wires inside the device leave enough space for the board if you

are installing a four-button board. Tighten the four screws thoroughly with the

wrench enclosed (Torx 20) to make the panel fit tightly to the metal chassis.

Caution

Properly installed intercom is waterproof. An incorrect mounting may

compromise the intercom watertightness. Water leakage may damage the

electronic part of the system.

Stainless steel screws are used for the assembly. 2N

Helios IP Safety

Other screws than stainless steel ones corrode soon and may aesthetically

deteriorate the surrounding environment!

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 44 45

Sin comentarios

2N Telecommunications 9152101 Manual de instalación Pagina 26